A Quick View of the USB Power Delivery Profile for the Insignia Switch Dock Kit AC Adapter

The Insignia Switch Dock Kit AC Adapter was bundled with the Insignia Switch Dock Kit to keep the dock charged up to 39W using USB Power Delivery over the USB Type-C interface. The power adapter claims to support the common USB Power Delivery profiles of 15 watts (5 volts @ 3 amps), 27 watts (9 volts @ 3 amps), and 39 watts (15 volts @ 2.6 amps), which we verified using the USB Power Delivery Compliance C2 Tester from Granite River Labs to run just a subset of the full USB Power Delivery compliance test suite. Note some compliance failures were observed.

DUT Information

Manufacturer	Insignia
Model Number	40W PD Charger
Serial Number	Comm

Test Information

Date and Time:

20180627_185221

Controller and Instrument Information

Parameter	Value
GRL USB-PD_C2 Serial No.	080.069.080.065.132.
GRL USB-PD Software Version	1.3.4.5
GRL USB-PD Firmware Version	1.3.5.0.12
Board Calibration	Calibration Success.
App Mode	COMMUNICATION_ENGINE_TESTS
Tx Mask	true
Rx Mask	false
RX mask Power selection	Neutral Power
Device Type	Provider Only
Cable IR drop Imp(R)	0
Cable Type.	USB-Type-C-Cable
COMMUNICATION_ENGINE_TESTS CTS Version	1.06
Noise Pattern Generation:	GEN-2 Noise
VIF info	*Since VIF was not loaded below test results are information Only.

Product Capabilities

Parameter	GetCapabilities
Type_C	NONE
SOP_Capable	NONE
SOP_P_Capable	NONE
SOP_PP_Capable	NONE
SOP_P_Debug_Capable	NONE
SOP_PP_Debug_Capable	NONE
Manufacturer_Info_Supported_Port	NONE
USB_Comms_Capable	NO
DR_Swap_To_DFP_Supported	NO
DR_Swap_To_UFP_Supported	NO
Externally_Powered	YES
VCONN_Swap_To_On_Supported	NONE
VCONN_Swap_To_Off_Supported	NONE
Responds_To_Discov	NONE
Attempts_Discov	NONE
Chunking_Implemented_SOP	NO
Unchunked_Extended_Messages_Supported	NO
Accepts_PR_Swap_As_Src	NO
Accepts_PR_Swap_As_Snk	NO
Requests_PR_Swap_As_Src	NONE
Requests_PR_Swap_As_Snk	NONE
Data_Capable_as_USB_Host	NONE
Data_Capable_as_USB_Device	NONE
Modal_Operation_Supported	NONE
Security_Msgs_Supported_SOP	NO
SVIDs Min	0
SVIDs Max	0
SVID Fixed	NONE

Power Capabilities

Parameter	GetCapabilities
No_USB_Suspend_May_Be_Set	NONE
GiveBack_May_Be_Set	NONE
Higher_Capability_Set	NONE
USB Suspend may be cleared	NO
Send Ping	NONE
Supply Type #1	Fixed
Peak Current #1	0x0(A)
Voltage #1	0x64(5V)
Max Current #1	0x12C(3A)
Supply Type #2	Fixed
Peak Current #2	0x0(A)
Voltage #2	0xB4(9V)
Max Current #2	0x12C(3A)
Supply Type #3	Fixed
Peak Current #3	0x0(A)
Voltage #3	0x12C(15V)
Max Current #3	0x104(2.6A)
No_USB_Suspend_May_Be_Set	NONE
GiveBack_May_Be_Set	NONE
Higher_Capability_Set	NONE

USB-IF High Level Mapping Summary

Sl No	Test Category	Test Group Description	Test Result
1	PHY_PRIMARY_TX	BMC Physical Layer Transmitter	PASS
2	PHY_PRIMARY_RX	BMC Physical Layer Receiver	FAIL
3	PHY_PRIMARY_MISC	BMC Phyiscal Layer Miscellaneous	PASS
4	PROT_PRIMARY	Protocol Specific Primary	PASS
5	POWER_PRIMARY	Power Source/Sink Primary	PASS

Result Summary

Sl No	Test ID	Test Name	Test Result
1	TDA.2.1.1.1	BMC-PHY-TX-EYE	PASS
2	TDA.2.1.1.2	BMC-PHY-TX-BIT	PASS
3	TDA.2.1.2.2	BMC-PHY-RX-INT-REJ	FAIL
4	TDA.2.1.2.1	BMC-PHY-RX-BUSIDL	PASS
5	TDA.2.1.3.1	BMC-PHY-TERM	PASS
7	TDA.2.2.1	BMC-PROT-SEQ-GETCAPS	PASS
11	TDA.2.2.7	BMC-PROT-BIST-NOT-5V-SRC	PASS
13	TDA.2.3.1.1	POW-SRC-LOAD-P-PC	PASS
14	TDA.2.3.2.1	POW-SRC-TRANS-P-PC	PASS
15	TDB.2.2.9	BMC-PROT-GSC-REC	PASS

BMC Eye Diagram

The load trace diagram below was captured using the GRL-USB-PD C2 Compliance Test Solution App that shows the Insignia Switch Dock Kit AC Adapter supporting various voltage and current levels for charging.